Rockwell Automation 1772-LS_LSP,D17726.8.6 PROG/OPER MANUAL-MINI PLC-2/05 - Manual (Page 204)

Report Generation
Chapter 17
17-10
Table 17.E
Report Generation Commands
Command Key Sequence Description
Enter report generation
function
[RECORD][DISPLAY] or Set baud rate, (Message
Code Keys)
Puts industrial terminal into report
generation function.
Same (entered from a peripheral device).
Message store [M][S][,](Message Number)[RETURN] Stores message in processor memory. Use [ESC]
to end message.
Message print [M][P][,](Message Number) [RETURN] Prints message exactly as entered.
Message report [M][R][,](Message Number) [RETURN] Prints message with current data table values or
bit status.
Message delete [M][D][,](Message Number) [RETURN] Removes message from processor memory.
Message index [M][I][RETURN] Lists messages used and the number of words in
each message.
Automatic report
generation.
[SEARCH][4][0] or [M][R][RETURN] Allows messages to be printed through
program control.
Exit automatic report
generation
[ESC] or [CANCEL COMMAND]
1
Terminates automatic report generation.
Exit report [ESC] or [CANCEL COMMAND]
1
Returns to ladder diagram display.
Terminates Report Generation Function.
[CANCEL COMMAND] can only be used if the function was entered by a command from a peripheral device.
1
Message Control Word File Ć MS, 0
Bits from eight consecutive user-selected words control the 64 additional
messages (1770-FD series B and all its subsequent revisions).
The eight message control words are determined by establishing a 2 -word
message in data table, called message 0. Store Message 0 by using the
following keystrokes:
[M][S][,] 0 [RETURN]