Rockwell Automation 1772-LS_LSP,D17726.8.6 PROG/OPER MANUAL-MINI PLC-2/05 - Manual (Page 106)

Math Instructions
Chapter 10
10Ć18
10. Enter if appropriate.
11. Press -[G]-.
12. Enter
13. Enter if appropriate.
14. Close the branches. Press the branch end key [ ].
15. Close the rung. Press [SHIFT][EAF].
16. Enter 05 (function number).
17. Enter 010 (data address).
18. Enter .
Editing a Completed Rung
Operand and Result: Follow the editing procedures for a Get instruction.
EAF Instruction: You can edit a square root operation to change an address by
performing the following steps.
1. Press [SHIFT][EAF].
2. Enter 05 (function number).
3. Enter 010 (data address).
4. Enter .
BCD to Binary
You must decide whether or not to enter a data address. If you choose to enter a
data address, the processor seeks the conversion number at that address in the
data table. If you choose not to enter a data address and use the default number
(010), the processor seeks its conversion number from the instructions in
the rung.
The ladder diagram that enables the processor to perform a BCD to Binary
conversion is shown in Figure 10.7. The default number is used as the
data address.