RKI Instruments SDM-2012 PC Controlled Configuration - Manual (Page 43)

Setting Up the PC Controller Program • 38
Setting Up the SDM-2012 Display Order
Setting up the display order for your SDM-2012s ensures that the docking stations
will appear in the PC Controller program in the same order that they are laid out in
your calibration area.
Before performing this operation, make sure your SDM-2012s are arranged on the
table top or other surface as desired and that they are connected to the computer.
See “Hardware Setup” on page 13. Also be sure that you have performed the driver
installations as described in “Installing the SDM-GX Docking Station PC Controller
Software” on page 24.
1. Click the Config button along the top of the screen to access the Configuration
Window.
2. You will be prompted to enter a password. The factory set password is
ABCDE. Enter the password and click OK keeping in mind that the password
is case sensitive. You may change the password using the Password Tab once
you have entered the Configuration Window. See “Password Tab” on page 175
for instructions to change the password.
3. The Parameter Tab of the Configuration Window will be displayed.
Figure 27: Config Window Parameter Tab