beautypg.com

Instrument panel, Description • 8, Ir port exhaust line (must be installed by user) – RKI Instruments SDM-2012 PC Controlled Configuration User Manual

Page 13

background image

Description • 8

Instrument Panel

The instrument panel is on the top of the SDM-2012 and includes the instrument
cradle, the IR port, the charging contacts, the exhaust line connection fitting, and the
gas out to instrument line. The instrument cradle consists of two recessed areas and
is designed to accept the instrument. The recess at the front of the instrument panel
is for instruments that have a Li-ion battery pack installed. Charging contacts are
located at the back of this recess. The recess behind the Li-ion battery pack cradle is
for instruments that have an alkaline battery pack installed. A plastic flap covers the
recess that is not in use. Insert the instrument into the appropriate instrument cradle
recess when you perform a bump test, calibrate, or charge an instrument. An infrared
(IR) port in the front recess lines up with the instrument’s IR port when it is inserted in
either recess and is used to communicate with the instrument. The exhaust line
connection fitting is in the upper left corner of the instrument panel. The exhaust line
is not factory installed and must be installed by the user. An exhaust line storage
fitting is located along the right side of the instrument panel and accepts the fitting at
the end of the exhaust line for storage. The gas out to instrument line is coiled and
stored in a recess in the upper middle portion of the instrument panel.

Exhaust Line
Storage Fitting

Gas Out to
Instrument Line

Alkaline Battery
Pack Cradle

Charging Contacts

GX-2012 OFF

COPY

CHARGE

POWER

1SEC ON
3SEC OFF

IR Port

Exhaust Line (Must Be

Installed by User)

SDM-2012

CAL.

BUMP

Lithium Ion Battery
Pack Cradle

Exhaust Line Connection Fitting

EDIT

ENTER

Figure 7: Instrument Panel (Shown Without Recess Cover Flap)