RKI Instruments SDM-2012 PC Controlled Configuration - Manual (Page 161)

Instrument Function Menu • 156
NOTE: The following parameters are instrument parameters, not PC Controller
Program parameters, and with the exception of Calibration Interval and
Cal Check Gas, do not affect the operation of the PC Controller
Program. Since the PC Controller Program uses the Calibration
Interval and Cal Check Gas settings retrieved from the instrument to
determine if a calibration is due, changing these settings will affect the
program’s operation.
Several instrument parameters are always selectable and do not depend on which
sub tab is selected.
• Serial No.: To change the current instrument serial number, place the cursor in
the Serial No. field and enter the desired serial number. If you change the serial
number, once you upload the changes to the instrument and return to the main
program window, the PC Controller Program will indicate that the instrument
with the old serial number was disconnected. An instrument with the new serial
number will then connect to the PC Controller Program.
• Station ID: To change the station ID, select the drop-down menu and select the
desired station ID. To change the station ID list, see “Station & User Tab” on
page 167.
Figure 127: Parameter Tab