MTS SWIFT 20 Ultra Sensor - Manual (Page 94)

SWIFT 20 Sensors 94
Test Track Vehicle for Slip Ring Sensor
Installing the Transducer
B. Rotate the tire 1 1/4 to 2 revolutions, until the Bridge Zero indicator
starts flashing. Follow the guidelines in
, “Considerations for rotating a
tire,” on page 85.
C. If the Bridge Zero indicator continues to slowly flash after 2 minutes,
or if the red Fail indicator flashes, there is an error in the zero process.
Run TISTATUS to find out more information. Repeat Steps A and B. If
you continue to have an error, consult the chapter
, “Troubleshooting,”
on page 127
D. Perform , “Verifying the Quality of the Zero Procedure,” on page 95.
E. Look at your data acquisition system to verify that the SWIFT sensor is
gathering data.