MTS SWIFT 20 Ultra Sensor - Manual (Page 79)

Test Track Vehicle for Slip Ring Sensor
SWIFT 20 Sensors Installing the Transducer 79
6. Tighten the mounting bolts.
A. Following the sequence shown in the previous figure for the transducer
being installed, torque the inner hub bolts in two increments, as shown
in the following table.
Important For the SWIFT 20T, the M8 bolts in the inner bolt pattern (bolts 1–4
in the previous figure) must be torqued, as described, before
torquing the M10 bolts (bolts 5–20 in the previous figure).
Note To minimize negative clamping effects, you must torque the bolts in the
sequence shown.
B. Following the sequence shown in the previous figure for the transducer
being installed, torque the outer hub bolts in two increments as shown
in the previous table.
Important For the SWIFT 20T, the M8 bolts in the outer bolt pattern (bolts 1–8
in the previous figure) must be torqued, as described, before
torquing the M10 bolts (bolts 9–24 in the previous figure).
Note To minimize negative clamping effects, you must torque the bolts in the
sequence shown.
Torque Increment SWIFT 20A SWIFT 20T
Bolt Size M8 M8 M10
1st Increment 14 N•m (10 lbf•ft) 14 N•m (10 lbf•ft) 27 N•m (20 lbf•ft)
Final Torque 27 N•m (20 lbf•ft) 27 N•m (20 lbf•ft) 54 N•m (40 lbf•ft)