Lenze EVF9333−xV - Manual (Page 382)

Configuration
Code table
8
8.5
l
8.5−34 EDSVF9333V EN 4.0−11/2007
IMPORTANT Possible settings Code
Selection Lenze Name No.
C0536 −32767 {1} 32767 Function block DFSET
l Display of the signals linked in
C0521, C0522 and C0523
^
8.2−18
1 DIS: VP−DIV
2 DIS: RAT−DIV
3 DIS: A−TRIM
C0537 DIS: N−TRIM −199.99 {0.01 %} 199.99 Function block DFSET
l Display of the signal linked in
C0524
C0538 0 1 Function block DFSET
l Display of the signals linked in
C0525, C0526 and C0527
1 DIS: 0−pulse
2 DIS: RESET
3 DIS: SET
C0539 DIS: IN −6000 {1 rpm} 6000 Function block DFSET
l Display of the signal linked in
C0520
C0540
s
Function 0 Function selection, function block
DFOUT
l Output signal at X10
^ 8.2−8
0 Analog input Analog input Signal at DFOUT−AN−IN is output.
Zero track can be input externally.
1 PH diff input Phase difference
input Signal at DFOUT−DF−IN is output.
Zero track can be input externally.
2 Not assigned
3 Not assigned
4 X10 = X9 X9 is output on
X10 The input signals are buffered
C0030 is without function
5 X10 = X8 X8 is output on
X10
C0541
s
CFG: AN−IN 5001 MCTRL−NACT ^ Selection list 1 Configuration of analog input
signal, function block DFOUT
l Signal in [%] of C0011
C0542
s
CFG: DF−IN 1000 FIXEDPHI−0 ^ Selection list 4 Configuration of input signal,
function block DFOUT
l Speed signal
C0544
s
CFG: SYN−RDY 1000 FIXED0 ^ Selection list 2 Configuration of digital input
signal, function block DFOUT
l DFOUT−SYN−RDY = HIGH:
Generating a zero pulse
C0545 PH offset 0 0 {1 inc.} 65535 Phase offset, function block
DFOUT
l Displacing the zero pulse
generated via DFOUT−SYN−RDY
by up to 360 °
l 1 rev. = 65535 inc (360 °)
C0546 Min inc/rev 1000 1 {1 inc.} 2147483647 Masking of the touch probe signal,
function block DFSET
l Suppressing interference
pulses at X5/E4 (actual pulse of
touch probe signal)
l The size of the masking
window between two actual
pulses is set
^
8.2−18