Lenze EVF9333−xV - Manual (Page 292)

Configuration
Function blocks
Internal motor control with V/f characteristic control (MCTRL1)
8
8.2
8.2.6
l
8.2−30 EDSVF9333V EN 6.2−04/2012
IMPORTANT Possible settings Code
Selection Lenze Name No.
C0105 QSP Tif 5.00 0.00 {0.01 s} 999.90 Quick stop deceleration time
l The deceleration time refers to
a speed variation of C0011 ... 0
^
8.2−25
^
8.2−48
C0107 holding time 0.00 0.00 {0.01 s} 9999.90 Hold time for automatic DC
injection braking (Auto−GSB)
^
8.2−25
^
8.2−48
C0132
s
Controller
enable fly
delay à 0 {1 ms} 9999 Minimum time for controller
inhibit with active flying restart
circuit, delays the start of the
flying restart process after
controller enable
à depending on C0082, C0086,
C0087, C0088, C0089, C0090,
C0091, C0092
A change of one of the codes
resets C0132 to the minimum
time of the selected motor
l The time is derived from the
double rotor time constant
^
8.2−25
^
8.2−48
C0140
s
select direct 0 Search direction during flying
restart process
l Positive direction of rotation:
The motor rotates in CW
direction with view on the
motor shaft
l Negative direction of rotation:
The motor rotates in CCW
direction with view on the
motor shaft
^
8.2−25
^
8.2−48
0 NSET Only search in the direction of the
applied setpoint
1 inv. Nset Only search against the direction
of the applied setpoint
2 pos. Only search in positive direction of
rotation
3 neg. Only search in negative direction
of rotation
4 Both, Nset Search at first in the direction of
the applied setpoint and then
against the direction
5 Both, inv. Nset Search at first against the
direction and then in the direction
of the applied setpoint
6 Both pos. Search at first in positive then in
negative direction of rotation
7 Both neg. Search at first in negative then in
positive direction of rotation