Lenze 8615E - Manual (Page 92)

With control and programming via keypad or LECOM
you
the loading of a Parameter set CO02.
you also load the factory setting.
Code Name Parameter (Factory setting is printed in bold) Acceptance
L o a d Factory setting [SH + PRG]
Parameter set Parameter set 1
Parameter set 2
Parameter 3
Parameter set 4
Reset D-component dancer-Position controller
In the configurations with dancer-Position controller, you set the
integral-action component or the differential component to zero via
the assigned input. Please observe the given on page 81
when assigning the inputs.
Suppression of the dancer-Position controller
The dancer-Position controller be suppressed via the assigned
input. you want to use the input for overlaying the controller, the
polarity of the input
be inverted by setting Cl 14 1. Please
observe the given on page 81 when assigning the inputs.
5.2.12 Reset of the compensation
The compensation be reset to zero via the assigned
input. Please observe the given on page 81 when assigning
the inputs.
5.3 Freely assignable digital Outputs, relay output
Factory setting
Output
A l Frequency below a certain
A 2 M a x i m u m r e a c h e d
A 3 reached
A 4 n o f u n c t i o n
Kl4 R e l a y o u t p u t : F a u l t
Terminal A4 is used as frequency output via S2 (factoty setting).
If you want to use A4 as freely assignable digital output, remove the of the
controller and set the as shown on page 32.
L e v e l
LOW active
HIGH active
HIGH active
LOW active
Contact open
Changing the
If you want to assign an output with a function, has not been
assigned yet, proceed as follows:
l
Select the output you want to assign Cl 16.
l
Select the required function Cl 17.
l
Determine Cl 18 the is activated at
HIGH or LOW.
90