Lenze 8615E - Manual (Page 150)

Service
1 Fault indication
When a fault occurs, the Operation of the frequency
immediately interrupted and the “ready” removed. The
fault is displayed automatically C067. The fault indication is
flashing as long as the fault has not been reset.
Fault reset: Press SH + PRG
or
reset.
Reset fault indications are stored. They be displayed again by
selected CO67 and pressing the DOWN-key in the Parameter
A maximum of eight faults be displayed: the most
fault is displayed first; then one preceeding this and so on.
Operation via LECOM interfaces
With Operation via LECOM interfaces, a fault is also displayed
C067, but as number (see table). Reset fault indications are
stored Cl 61 to Cl 68.
You reset the fault by selecting Parameter -0-
co43.
148