Lenze 8615E - Manual (Page 60)

2.1 Parameter setting by two
Some Parameters are set by two A preselection is
used to select the Parameter is to be changed. The
Parameter is then changed by another For example, to set
the JOG frequency JOG3, first set the preselection CO38 to
and then set the desired frequency for JOG3 via C039.
2.2 Save Parameters
After the acceptance, new Parameters are saved in the RAM
the controller is connected to mains voltage.
If you want to permanently save your process as follows:
. Select CO03.
l
Select i.e. Parameter set 1.
l
First press SH and then in addition PRG. The display
Now you disconnect the controller from the mains. Your
settings are saved permanently “Parameter set 1”.
Ta save different Parameter see page89.
2.3 Load Parameters
If you only need one Parameter set, you permanently save your
Parameter set After every mains connection,
Parameter set 1 is loaded automatically. To load different
Parameter
see page 89.
58