Lenze 8615E - Manual (Page 85)

5.2.3 brake
you want to brake the drive fast, but do not want to use a brake
you activate the DC-injection brake via the
input. Please note that the braking time may vary time.
Before you use the brake, set the brake voltage
C036. The brake voltage also determines the brake current
and therefore the brake torque. the current limitation is activated
by the brake current, reduce the brake voltage.
To limit the time of the brake, you a
holding time After the holding time has elapsed, the
switches the output voltage to With a holding time
of 999s the braking time is unlimited.
Extended Operation of the brake may the motor
to overheat!
Code
CO36 Voltage for 0%
Name Parameter (Factory setting is printed in bold) Acceptance
0 % (0.1 40%
D C - i n j e c t i o n
brake
Cl07 H o l d i n g t i m e 999 s 0.00 s (10 ms) 1 s ON-LINE
for 1.0s (100 ms) 10.0s
injection brake 1 0 s 100s
100s 999 s
I N F O : 9 9 9 s U n l i m i t e d h o l d i n g t i m e
With ,terminal control CO48 serves as display whether the
injection brake is
or not.
With control via the keypad or the the
injection brake is (de-)activated via C048.
Code Name Parameter (Factory setting is printed in bold)
Enable DC-injection brake
injection brake DC-injection brake
For information the DC injection brake see
page 97.
Acceptance
SH PRG
83