Lenze 8615E - Manual (Page 79)

M Torque characteristic of the motor
Stationary
Operation
= act. value
Output frequency
Pilot control of
Closed-loop control without control, closed-loop control
of an application datum
The Pl
is normally used for the control of the
connected motor. The large setting of the control
Parameters also the control of an application datum if this
depends on the drive For this it may be to
off the frequency control and to set the Pl Controller to 100%
influence.
The act. value gain and the control Parameters must be adjusted
according to the corresponding conditions.
With value
77