Lenze 8615E - Manual (Page 58)

2 Basic Parameter setting
Programming of the frequency controller enables the drive to be
adapted to your application. The possible settings are arranged in
which are numbered in and with the
letter provides one Parameter which be
selected according to the application.
Parameters be absolute or relative values of a physical unit
(e.g. or 50% related or giving
certain information controller inhibited,
controller enabled).
In where the Parameters represent values of physical units,
it is possible that the increment varies.
Example: The maximum field frequency
be set in increments
of 0.1 Hz up to 1 and in increments of Hz from
upwards.
In some Parameters only be read but not changed.
In the factory setting, only those are displayed which are
for the most common applications. For activation of the
extended set see page 100.
2.1 Changing Parameters
has a factory set Parameter which be changed.
There are three different ways of selecting another Parameter,
depending on the
acceptance
The controller immediately accepts the new Parameter, i.e. while
you
it using the UP or DOWN keys. This is possible even
when the drive is running.
Parameters which are immediately accepted are marked with ON-
LINE in the following programming tables.
Example:
the controller the momentary field frequency in
Hz. You want to set a maximum field frequency (CO1 1) of
56