Lenze 8615E - Manual (Page 110)

9.6 of the configoration
The setting of determines which input channels and which
controls will be
Configuration 1 2
line d a n c e r
Terminals (bipolar) or LECOM Terminal s
o p e r a t i n g u n i t ( b i p o l a r )
.
Terminals
(bipolar) analog actual value
-202- , , Master frequency Terminals Terminals
( b i p o l a r ) analog actual value
__
,
9.7 Diameter and radius detection
The is detected by means of ultrasonic which
emit a distance or a real radius Consequently, there
are different procedures to adapt the internal processing.
The is always provided via the terminals 1 and 2.
This is converted with a resolution of 12 bits sign bit
(this corresponds a resolution of 4096; resulting in a
resolution of 1 =
The input is equipped with a which largely suppresses
interference on the ultrasonic when the field frequency is
9.7.1 Signal of the ultrasonic Sensor: distance
For the adjustment of the radius detection when an ultrasonic
which supplies a distance the sensor-axis distance
be entered This value be entered in
Calculation of the value for Cl 80:
For the calculation the bale have any diameter. (lt does not
make any whether the or the maximum
is assumed.)
The value for Cl80 is calculated from the distance in
detected by the ultrasonic and the measures distance as
weil as the bale radius.
value input
+
Cl80 = Distance =
L
+
m m