Lenze 8615E - Manual (Page 144)

12.3.5 Baud rate (LECOMI)
25 you enter different baud
Code Parameter Meaning
4 8 0 0 baud
-2- 2 4 0 0 b a u d
1200 baud
12.3.6 History of reset faults
Cl 61 to 68 you read the last eight faults stored. The
last reset fault is displayed in Cl 61.
12.3.7 Code bank (LECOMI)
With 1 .O of the LECOM protocol, up to C255
be processed. To also numbers with this Version, the
accessible range be by C249. Code C249 exists
in every range.
Parameter In C249 Access to range
information serial communication with the
interface be obtained from the
technical description LECOM-A/B, we will be pleased to send
you on request.
12.3.8 Enable automation interface (LECOM2)
If you want to integrate the controller into automation
you connect an interface, Interbus-S or Profibus
or an automation module. the module and activate it
Code Parameter Meaning
No communication via automation interface
(LECOM2)
Communication via automation (LECOM2)
If the communication via is enabled but an automation
module is not connected, the controller is inhibited.
142