1 example of how to select a configuration – Lenze 8615E User Manual
Page 65
3.2.1
Example of how to select a configuration
The
of rotation of the motor in a
is to be
determined by the sign of the analog
for CW
rotating field,
for CCW rotating field).
A closed-loop
control is to be used, for
a DC
serves as act. value. A
2 is not used.
The corresponding configuration
be determined as follows:
The table “Closed-loop
control” contains two configurations
where the
1 is provided analog as bipolar setpoint. These
are the Parameters -1 and
The desired closed-loop
control using DC tachogenerator is possible with Parameter
-1
The
2 via terminals and 2 is
but is not
required. Therefore its influence must be set to zero as
from
couplings. Please observe the
on page 68.
63
This manual is related to the following products: