Lenze 8615E - Manual (Page 105)

9.1.2 Line drives
l
Dancer-Position control with and without control of the line
l
Dancer-Position control with adaptation and control
of the line
L
-v
T
drive
9.1.3 Grinding and cutting-off wheel drives
l
of contstant via non-contact
d
Grinding wheel drives
Important information the dancer-Position control:
l
analog inputs Xl 2 and 3, 4 are
always independently of the operating mode.
l
‘When reading the following setting instructions, please note that
requires the maximum frequency of the
drive.
103