Lenze 8615E - Manual (Page 59)

The arrow marks whether you are in the or in the
Parameter
Press, until CO1 1 is displayed
‘0 ‘1 ‘5 ‘0 ‘0 ‘H
m a. x f ‘r
PRG to Change to the Parameter level
5 ‘0
f ‘e ‘n ‘c
until 60 Hz is displayed
6 ‘0 ‘0
m x f ‘r
The maximum field frequency of is now set and is accepted
immediately.
Acceptance with SH + PRG
The controller accepts a new Parameter when are
pressed. This is possible even when the drive is running.
First press SH and then in addition PRG. The display
for 0.5 seconds. The controller now works with the new Parameter.
The key combination SH and PRG be compared to the “return”
key your Computer keyboard.
have to set a Parameter in this way, the programming tables
show the SH + PRG.
Acceptance with SH + PRG with controller inhibit
The controller accepts the new Parameter when the controller has
been inhibited before pressing SH + PRG.
the controller, e.g. by pressing STP.
First press SH and than in addition PRG. The display
for seconds. The controller works with the new Parameter
when controller inhibit is cancelled.
If you have to set a Parameter in this way, the programming tables
show the [SH + PRG].
57