Lenze 8615E - Manual (Page 75)

3.8 Minimum field
You use CO10 to a output frequency.
This the influence of the analog to 1 in
the factory-set configuration = -0- (not for other
configurations).
1
,analog
100% 8
For inputs via keypad or LECOM interfaces, the
setting is not
Name Parameter (Factory setting is printed in bold) Acceptance
Minimum field Hz 0.0 Hz (0.1 Hz] 100 Hz ON-LINE
frequency 1 0 0 H z 480 Hz
3.9 Maximum field
Via CO1 you select a maximum field frequency between 7.5
and 480 Hz. The value will be a reference for the analog and
scaled
input and for the acceleration and deceleration
times. For absolute input, via keypad or JOG
frecluencies, is the linlit
a configuration with Pl (CO05 = the
output be up to 200%
When you want to the maximum field frequency in large
increments via the LECOM interfaces, first inhibit the Controller.
Code Name Parameter (Factory setting is printed in bold) Acceptance
CO1 1 Maximum field 50 Hz 7.5 Hz Hz) 100 Hz ON-LINE
frequency 480 Hz
73