Lenze 8615E - Manual (Page 90)

5.2.6 Ramp generator stop
While the drive is accelerated via the ramp generator of the main
setpoint, you hold the ramp generator using the assigned
digital input, to wait for cet-tain before accelerating.
With terminal control you read whether the
ramp generator is stopped or not.
With control via the keypad or the LECOM interfaces the ramp
generator (main setpoint) is stopped and enabled again
C131.
Code Name Parameter ( F a c t o r y s e t t i n g i s p r i n t e d i n b o l d ) Acceptance
Ramp gener. ramp generator SH + PRG
stop Stop ramp generator
5.2.7 Ramp generator input =
you want to stop the drive independently of the main
(setpoint frequency) you the ramp generator
input input to zero using the assigned input. This the drive
to brake with the set deceleration time. When the is
deactivated, the main is enabled again and the drive
accelerates normally.
With terminal control serves as display whether the ramp
generator input is set to zero or not.
With control via keypad or LECOM interfaces you set the ramp
generator to zero and enable it again Cl 32.
Code Name Parameter (Factory setting is printed in bold) Acceptance
Cl32 R a m p g e n e r a t o r i n p u t e n a b l e d SH PRG
generator input Ramp generator input =
0 set to zero
5.2.8 Integral action component =
In configurations with Pl controller you set the integral action
component of the controller to zero using the assigned input. See
page 80.
88