INFICON Composer Gas Concentration Controller - Manual (Page 156)

8 - 2
IP
N 07
4-
28
9L
Composer Operating Manual
8.2.1 Computer System Requirements
8.2.2 Software Installation
Either the Composer Monitor or the Setup Tool software can be installed in a
computer with either Windows 95, Windows 98 or Windows NT operating
system.
1 Insert the installation disk #1 into your floppy disk drive, typically " a ".
2 In the Start Menu, select Settings >> Control Panel.
3 In the Control Panel double click on Add/Remove Programs.
4 Click on the Install button in the upper right of the dialog box.
5 Follow the directions to complete the installation.
NOTE: Depending upon your computer system, you may be prompted to
reboot the system after it updates older system files in your computer.
In this case, go back to step 1 after rebooting your computer.
6 It will prompt you for the final destination directory. The default destination
is
c:\Program Files\Composer Monitor
or
c:\Program
Files\Composer Setup Tool , depending on the software being
installed. If you select a directory other than the default, be sure to setup the
log file before logging any data.
7 When the Installation is complete, put the original disks in a safe storage
area.
Table 8-1 Computer System Requirements
Minimum System Recommended System
Processor Pentium 166MHz Pentium II 350MHz
RAM 32 Mb (Win95, Win98)
64 Mb (Win NT) 64 Mb
Hard Disk Space
(Program) 4Mb 4Mb
Hard Disk Space
Data (24 hours) approx. 24 Mb approx. 24 Mb per
sensor
Monitor 14 inch, VGA 17 inch, SVGA
Resolution 800 x 600 800 x 600 or better