Dakota Ultrasonics DFX-8 plus MANUAL2 - Manual (Page 32)

Dakota Ultrasonics
28
COATING 1PT: Performs a single point coating calibration. This option allows the
user to automatically calculate the velocity by measuring a known coating sample
thickness. Refer to page 107 for further info.
COATING 2PT: Performs a two-point coating calibration. This option allows the
user to automatically calculate the velocity by entering a second known coating
sample thickness. Refer to page 107 for further info.
COATING VEL: Function to calibrate the DFX-8 to a specific coating material type
by entering a coating velocity. Refer to page 17 or page 101 for further info.
3.4 DISP (display) – Menu
VIEW: Selectable BSCAN (cross section), and DIGITS (large digits) views. Refer to
page 64 for further info.
DELAY (B-START): Provides the user the ability to change the start position of the
B-SCAN view. Refer to page 72 for further info.
RANGE (B-DEPTH): Provides the user the ability to change the overall depth of the
viewable measurement area. It functions a lot like a zoom on a camera. Refer to
page 74 for further info.
B-SCAN SPEED: Controls the speed of the time based B-Scan with an arbitrary
scale of 0-10, with 10 being the fastest scrolling speed. Default speed set at 6.
Refer to page 76 for further info.
UNITS: Toggle between English or Metric units. The readout will change from
inches to millimeters.
BRIGHTNESS: Blanview high speed color display. An arbitrary scale of 1-20 has
been implemented, with the brightest setting at 20. Refer to page 118 for further info.
COLOR: Provides the user with 12 different color schemes to select from. There are
two schemes for each main color option. Refer to page 119 for further info.
DIM: Allows the user to conserve battery life by diming the display after idle for a
specific amount of time – OFF, 30, 60, 90, 120 seconds. Once dimmed, a single
press of any key will restore the screen brightness. Refer to page 121 for further info.
RECT WAVE: This option provides the user an outlined or filled view option when
the display setting is in RECT (rectified) wave mode only. Refer to page 123 for
further info.
DETECT MARK: Selectable graphics option for the point of detection on the
waveform: Line, Box, Dots, None. Offers the user a graphics preference on how
they prefer to view the detection on the waveform.