Dakota Ultrasonics DFX-8 plus MANUAL2 User Manual
Page 115
DFX-8
Ultrasonic Thickness Gauge
111
3) Use the
UP and DOWN arrow keys multiple times using the left button
wheel to scroll through the sub menu items until COATING 2PT is
highlighted.
4) Press the ENTER key to display the Digits Edit Box.
5) Press the
UP and DOWN arrow keys multiple times using the left button
wheel to scroll the highlighted value.
6) Press the
LEFT and RIGHT arrow keys multiple times using the left
button wheel to scroll the digit locations.
7) Repeat steps 5 & 6 until the known thickness value is correctly displayed.
8) Press the OK key to calculate the velocity and return to the menu screen, or
ESC to cancel the coating one point calibration.
9) Finally, press the MEAS key to return to the measurement screen and begin
taking readings.
Note: CHECK YOUR CALIBRATION! Place the transducer back on both
calibration points. The coating thickness readings should now match the known
thickness values of each sample. If the thickness is not correct, repeat the
steps above.