Dakota Ultrasonics DFX-8 plus MANUAL2 - Manual (Page 150)

Dakota Ultrasonics
146
Grid Log Sequential Log
3) Press the OK key to save the New Grid or Seq Log, or the ESC key to
cancel the New Grid or Seq Log setup and return to the DATA menu.
4) Press the MEAS key to return to the measurement screen and begin storing
readings.
11.3 Storing a reading
Now that a grid or sequential log has been created, it’s time to make some
measurements and store the readings. The following procedures outline this
process:
Storing a Reading
Note: Once the gird or sequential log has been created it will automatically be
displayed following the create confirmation screen. It is located at the bottom of
the measurement screen, and can be left open for the duration of the inspection
process. This section assumes the grid or sequential log was just created.
Refer to the section on “opening a grid or seq log” if the file was created at
another time.