Dakota Ultrasonics DFX-8 plus MANUAL2 - Manual (Page 11)

DFX-8
Ultrasonic Thickness Gauge
7
>> End
DATA UTILS XFER
NEW AUTO FIND BACKUP
SETUPS
EDIT SCAN MODE COPY DATA
OPEN ALARM COPY
SCREENS
CLOSE ALARM HIGH UPGRADE
GAUGE
DELETE ONE
FILE
ALARM LOW CAPTURE TO
FILE
DELETE ALL
DATA
DIFFERENTIAL STORAGE
GAUGE ABOUT
2.4 Auto Probe Recognition
When the DFX-8 is initially powered up, the gauge will automatically check to see if
the transducer plugged into the gauge can be recognized. The steps that follow
assume the DFX-8 recognized the probe type:
Probe Automatically Recognized
1) Press the OK key once to use the identified probe, or ESC to display a list of
optional transducers. Note: if the DFX-8 recognizes a specific transducer,
the user should always select OK to use the identified probe. The only time