Initializing the embroidery unit, Installing the embroidery unit – Brother PC 6500 User Manual

Page 90

1. Turn on the sewing machine. The message shown at the left

appears on the screen.

Note
If the buttonhole lever, the needle or the presser foot lever are
lowered or if the bobbin winding shaft is moved to the right, an
error message appears indicating the current error condition.
After the error condition is corrected, the message shown at the
left appears.

2. Press

. The embroidery arm moves to its initial

position.

CAUTION
–

Do not place your hands near the embroidery arm,
otherwise injuries may occur.

–

Please note that the embroidery arm normally makes
noises while it moves to its initial position.

–

If the embroidery unit could not be initialized normally,
a buzzer will sound. If this occurs, make sure that a
embroidery frame is not attached and try initializing the
embroidery unit again.

Initializing the embroidery unit

CAUTION
–

Always turn off the main power switch before connecting or removing the embroidery unit.

–

Do not touch the connector on the embroidery unit.

–

The foot controller cannot be used when the embroidery unit is operational.

–

When the embroidery unit is not being used, always store it in its box and packing materials.

–

Do not carry the machine with the embroidery unit connected.

–