Dart sewing – Brother PC 6500 User Manual
Page 47
44
DART SEWING
3
1
2
1. Attach presser foot J. Then, after sewing reverse stitches at
the beginning of the dart, sew from the wide end to the
narrow end without stretching the fabric.
1
Right side of fabric
2
Wrong side of fabric
3
Basting
Note
If automatic reverse/reinforcement stitching is turned on before
you start sewing, pressing just the start/stop button
automatically sews reverse stitches before sewing.
2. Press the start/stop button to stop stitching without sewing
reverse stitches at the end of the seam, cut the threads,
leaving about 2" (5.0 cm) of thread on the ends, and then tie
the two threads together at each end.
3. Insert the ends of the thread into the dart using a needle.
4. Iron the dart to one side so that it lays flat.
J
1
Straight (Left) [straight stitch (left needle position)]
1