The walking foot is useful for sewing materials that are hard to feed, such as vinyl cloth, synthetic leather,
thin leather, etc. This foot prevents such materials from crumpling, slipping or sticking by evenly feeding
both pieces of fabric.

The walking foot can only be used to sew the straight stitches (

and

) and the zigzag stitch

(

1. Remove the installed presser foot and the presser foot

holder.

2. Slide the presser foot adapter as high as possible up the

presser foot bar, and then fasten it by firmly tightening the
screw (for securing adapter) with the enclosed screwdriver
or disc-shaped screwdriver.

Screw (for securing adapter)

Note
If the screw is not completely tightened, injuries may occur.

3. Hook the connecting fork of the walking foot onto the needle

clamp screw, lower the presser foot lever, and then fasten
the walking foot by firmly tightening the screw (for securing
presser foot) with the enclosed screwdriver or disc-shaped
screwdriver.

Connecting fork

Screw (for securing presser foot)

Note
–

Before sewing, be sure to turn the balance wheel slowly
toward you to check that the needle does not touch the
presser foot, otherwise injuries may occur.

–

Sew at a slow to medium speed.

The presser foot adapter is used for attaching screw-on presser feet to this machine.

Adapter

Screw (for securing adapter)

Screw (for securing presser foot)

Installing the presser foot adapter & the walking foot