CAUTION
Be sure to turn off the power before attaching embroidery foot Q. If the power is left on and the start/stop
button is accidentally pressed, the machine will start operating, which could result in serious injury.

Installing embroidery foot Q

1. Press the needle position button to raise the needle, and

then turn off the sewing machine.

2. Raise the presser foot lever.

3. With the enclosed screwdriver or disc-shaped screwdriver,

loosen the screw on the presser foot holder, and then pull
the holder downward to remove it.

Presser foot holder

4. Slide the bracket on embroidery foot Q up onto the presser

foot bar, and then fasten it by firmly tightening the screw
with the enclosed screwdriver or disc-shaped screwdriver.

Embroidery foot Q

CAUTION
Be careful not to touch the tip of the needle, otherwise
injuries may occur.

Note
–

Make sure that embroidery foot Q is tightly attached to the
presser foot bar.

–

It is recommended that a 90/14-size needle be used when
embroidering thicker fabrics such as denim or when using
stabilizing products such as puffy foam. A 75/11-size needle
might bend or break, which could result in injuries.