Brother PC 6500 - Manual (Page 128)

This message appears when the start/stop button is pushed
while the foot controller is connected.
This message appears when the start/stop button, or
reverse/reinforcement stitch button is pressed, but no pattern
has been selected.
This message appears when the motor becomes locked, such
as when the thread is entangled.
This message appears when the start/stop button,
reverse/reinforcement stitch button, thread cutter button or the
foot controller is pressed while the presser foot lever is raised.
This message appears when the reverse/reinforcement stitch
button, needle position button or thread cutter button is pushed
while the bobbin winder shaft is moved to the right.
Warning messages
ERROR MESSAGES
If the machine is not properly set when the start/stop button is pressed, or if a correction of your operating
procedure is required, the machine will not start and will instruct you with an alarm and a warning message
on the LCD.
This message appears when the embroidery unit is being
initialized, but the presser foot is lowered.
This message appears when the start/stop button or
reverse/reinforcement stitch button is pressed while a pattern
other than a buttonhole is selected and the buttonhole lever is
lowered.
125
CONTENTS
SETTING UP
SEWING
UTILITY
STITCHES
MY CUSTOM
STITCH
TM
(CREATE
YOUR
OWN
STITCH
DESIGNS)
EMBROIDERING
MAINTENANCE
ERROR
MESSAGES
SEWING CHART
PATTERNS
(PROGRAMMED
IN MACHINE)