5 [ethernet, 1 [tcp/ip, Ethernet] -10 – Konica Minolta bizhub 42 User Manual
Page 35: Tcp/ip] -10
bizhub 42/36
4-10
4.5
[Ethernet]
4
4.5
[Ethernet]
Configure network settings.
These settings are required before using this machine via the network.
4.5.1
[TCP/IP]
Specify network settings for the machine.
If you change the setting items below and exit the Ethernet menu, the machine is rebooted.
-
[Enable]
-
[DHCP]
-
[BOOTP]
-
[ARP/PING]
-
[SLP]
-
[SNMP]
-
[IPv6]-[Enable]
-
[Auto Setting]
%
Press the Utility/Counter key ö [Admin Settings] ö [Ethernet] ö [TCP/IP].
Settings
[Enable]
Select the TCP/IP setting.
[ON]: Enables the TCP/IP setting.
[OFF]: Disables the TCP/IP setting. Items except for this one are not dis-
played.
[IP Address]
To directly specify the IP address, enter the IP address of this machine.
Format: *.*.*.* (Asterisk * can be 0 to 255)
If the IP address is specified here, the following items are set to [OFF].
•
DHCP
•
BOOTP
•
ARP/PING
[Subnet Mask]
When directly entering the IP address, configure the subnet mask of the
network to be connected.
Format: *.*.*.* (Asterisk * can be 0 to 255)
[Gateway]
When directly entering the IP address, specify the default gateway of the
network to be connected.
Format: *.*.*.* (Asterisk * can be 0 to 255)
[DHCP]
If there is a DHCP server on the network, specify whether the IP address
and other network information are automatically assigned by the DHCP
server.
If the IP address is manually specified, [DHCP] is automatically set to
[OFF].
[BOOTP]
If there is a BOOTP server on the network, specify whether the IP address
and other network information are automatically assigned by the BOOTP
server.
If the IP address is manually specified, [BOOTP] is automatically set to
[OFF].