Konica Minolta bizhub 42 User Manual
Page 216
bizhub 42/36
5-128
5.7
[Network] tab
5
[Context Name]
Enter a context name (up to 63 characters, exclud-
ing " ' # \ and space).
[Discovery]
If [Enable] is selected, the Discovery function is
enabled.
[Discovery User Name]
Enter a context user for detection (up to 32 char-
acters, excluding " ' # \ and space).
[Read User Name]
Enter a user name of the read-only user (up to 32
characters, excluding " ' # \ and space).
[Security Level]
Select a security level of the read-only user.
[Change Password]
Select this check box to change the password.
[auth-password]
Enter the password of the read-only user for au-
thentication (up to 32 from 8 characters, excluding
" ' # \ and space).
[Change Password]
Select this check box to change the password.
[priv-password]
Enter the privacy password of the read-only user
to be used for privacy (encryption) (up to 32 from
8 characters, excluding " ' # \ and space).
[Write User Name]
Enter a user name used of the read and write-only
user (up to 32 characters, excluding " ' # \ and
space).
[Security Level]
Select a security level of the read and write-only
user.
[Change Password]
Select this check box to change the password.
[auth-password]
Enter the password of the read and write-only user
for authentication (up to 32 from 8 characters, ex-
cluding " ' # \ and space).
[Change Password]
Select this check box to change the password.
[priv-password]
Enter the privacy password of the read and write-
only user to be used for privacy (encryption) (up to
32 from 8 characters, excluding " ' # \ and space).
[Encryption Algorithm]
Select an encryption algorithm.
[Authentication Method]
Select an authentication method.
[Trap Settings]
Configure the settings for SNMP TRAP.
[Allow Setting]
Select whether or not to permit the Trap settings.
[Trap Setting When Au-
thentication Fails]
Select whether to enable TRAP transmission at
the time of authentication failure.
Item
Description
Control Panel