Konica Minolta bizhub 42 - Manual (Page 225)

bizhub 42/36 5-137
5.7 [Network] tab 5
In Remote Printer mode using the NetWare 4.x Bindery Emulation
0 When you use the Bindery Emulation, make sure that the Bindery Emulation has been enabled on the
NetWare server.
1
From the client, log in the NetWare file system as Bindery with the administrator authority.
2
Start Pconsole.
3
Select [Quick Setup] from [Available Options] list box, and press the Enter key.
4
Fill in [Print Server Name], [Printer Name], and [Print Queue Name]. Set the [Type] of the printer to [Oth-
er/Unknown], and save them.
5
Terminate Pconsole by pressing the Esc key.
6
Load the PSERVER.NLM file on the NetWare Server console.
Then, configure the following settings in [NetWare Setting].
In Print Server mode using the NetWare 4.x Bindery Emulation
0 When you use the Bindery Emulation, make sure that the Bindery Emulation has been enabled on the
NetWare server.
0 When you select the Print Server mode, the IPX protocol must already be loaded on the NetWare server.
1
From the client, log in the NetWare file system as Bindery with the administrator authority.
2
Start Pconsole.
3
Select [Quick Setup] from [Available Options] list box, and press the Enter key.
4
Fill in [Print Server Name], [Printer Name], and [Print Queue Name]. Set the [Type] of the printer to [Oth-
er/Unknown], and save them.
5
Terminate Pconsole by pressing the Esc key.
Then, configure the following settings in [NetWare Setting].
Item Description Prior check
[IPX/SPX] Select [Enable].
[Ethernet Frame
Type] Select a frame type to be used. Frame type
[NetWare Print
Mode] Select [NPrinter/RPrinter].
[Printer Name] Enter a printer name to be operated as the NPrint-
er/RPrinter (up to 63 characters, excluding / \ : ; , * [ ] < > |
+ = ? .). The print server
name specified in
Step 4
[Printer Number] Enter the NPrinter/RPrinter number.
Item Description Prior check
[IPX/SPX] Select [Enable].
[Ethernet Frame
Type] Select a frame type to be used. Frame type
[NetWare Print
Mode] Select [PServer].
[Print Server Name] Enter a print server name to be operated as PServer (up to
63 characters, excluding / \ : ; , * [ ] < > | + = ? .). The print server
name specified in
Step 4
[Print Server Pass-
word] Enter a print server password if necessary (up to 63 char-
acters).