Konica Minolta bizhub 42 - Manual (Page 251)

bizhub 42/36 7-2
7.1 Using authentication unit 7
7 Authentication unit
This chapter describes the Authentication Unit AU-201.
1. Authentication Unit AU-201
7.1 Using authentication unit
The Authentication Unit AU-201 is an "IC card authentication" system that reads the IC card to perform per-
sonal authentication. Using this system, you can perform authentication with an IC card to log in to this ma-
chine or execute a print job when User Authentication is enabled in this machine.
To use the authentication unit, first register the card ID of the user in this machine. The registered user, who
is authenticated with the card ID, can log in to this machine or execute a print job. This section explains how
to configure the required settings in this machine, and register users.
NOTICE
Authentication Unit AU-201 must be installed inside the Working Table WT-510.
Do not disconnect the USB cable while using the authentication unit. Doing so may cause the system to be-
come unstable.
Do not leave the IC card within 1-9/16 inch (40 mm) of the card reader.
7.1.1 Configuring this machine
NOTICE
To configure IC card authentication, the loadable driver needs to be installed in the machine. For details, con-
tact your service representative.
User authentication settings must be configured with MFP authentication on this machine. You configure
user authentication using PageScope Web Connection.
This device does not support external server authentication. For [Public Access] or [Account Track] settings,
refer to page 5-22. To combine account track settings with user authentication settings, set Synchronize
User Authentication & Account Track to [Synchronize].
1
Log in to the administrator mode of PageScope Web Connection.
% For details on how to log in to the administrator mode of PageScope Web Connection, refer to
page 3-5.
2
Select [Security] ö [Authentication] ö [General Settings].
1