Konica Minolta bizhub 42 - Manual (Page 29)

bizhub 42/36 4-4
4.1 [Machine Settings] 4
[Auto Reset Settings] [Enable] Select whether or not to exit the current screen
and return to the home screen if the machine is
not used over a period of time.
d
Reference
If user authentication or enhanced se-
curity mode is enabled, the adminis-
trator settings mode or user
authentication mode is logged off ac-
cording to the setting for System Auto
Reset Time.
[Auto Reset] Specify the period of time before the auto reset
function starts working.
[Priority Mode] Configure a screen to be displayed in the system
auto reset mode.
[Shift Output Each Job] Select whether to shift the output paper for each job. This item is displayed
if the Finisher FS-529 is installed.
[Low Power Mode Setting] Set whether or not exchanged to low power mode. Low power mode refers
to a power saving state into which the machine automatically enters and in
which the touch panel goes off if the machine is not used over a period of
time.
[LowPowerMode Time Set-
ting] Set a time period before switching to the low power mode when this ma-
chine is not being operated. The following items can be set; [1 min.], [2
min.], [3 min.], [4 min.], [5 min.], [6 min.], [7 min.], [8 min.], [9 min.], [10 min.],
[11 min.], [12 min.], [13 min.], [14 min.], [15 min.], [30 min.], [45 min.], [1
Hour], or [3 Hours]. The low power switching time is always as long as the
sleeping time. If the switching time is longer, the sleep mode may come be-
fore the low power mode.
This item is not displayed if [Low Power Mode Setting] is set to [OFF].
Factory default
[Sleep Time Setting] bizhub 42
[1 Hour]
bizhub 36
[45 min.]
[Auto Power OFF Setting] This value varies depending on the area.
[Time Zone] [00:00]
[Daylight Saving Time] [OFF]
[Report Input Tray] [Tray 2]
[Auto Reset Settings] [Enable]: [ON]
[Auto Reset]: [1]
[Priority Mode]: [Home]
[Shift Output Each Job] [ON]
[Low Power Mode Setting] [ON]
[LowPowerMode Time Set-
ting] [15 min.]
Settings