Anritsu ML2430A - Manual (Page 251)

Mnemonic Action Supported? Restrictions
LM1 Limit check on Yes Both high and low on as HP 437B
LN Units to Watts Yes None
LP Learn mode 1 No Not supported
LT Left arrow No Not supported
MZ Terminator Yes None
OC0 RF calibrator off Yes None
OC1 RF calibrator on Yes None
OD Output display text Yes Supports reading output and Cal factor
table output only. (F=Factory table.)
OF0 Offset off Yes None
OF1 Offset on Yes None
OS Set offset value Yes OSDOEN not supported
PCT Terminator Yes None
PR Preset Yes None
RA Auto range Yes None
RC Recall setup Yes Limited to 10 stores
RE Resolution Yes Set screen decimal places
RF0-RF9 Sensor cal factors Yes None
RH Range hold Yes None
RL0 Relative mode off Yes None
RL1 New relative value Yes None
RL2 Use old relative value Yes None
RM Set sensor range Yes ML2430A ranges
*RST Reset Yes None
RT Right arrow No Not supported
RV Read SRE Yes None
SE Select data table Yes None
SM Status output Yes As much as has meaning for ML2430A.
Set to 0 if not used
SN0-SN9 Serial number Yes None
SP Special No Not supported
*SRE Set SRQ enables Yes None
*SRE? Read SRQ enables Yes None
ST Store setup Yes Limited to 10 stores
*STB? Read status byte Yes None
TR0 GPIB trigger hold Yes None
TR1 Immediate trigger Yes None
TR2 Settled trigger Yes None
TR3 Trigger hold off Yes None
*TST? Selftest Yes Always returns 0
UP Up arrow No Not supported
@1 Status mask Yes None
@2 Learn mode 2 No Not supported
% Terminator Yes None
ML2430A OM B-17
APPENDIX B HP-IB SUPPORT