Anritsu ML2430A - Manual (Page 147)

port: 1 or 2
val: –5.00 to +5.00 Volts
Remarks: Sets up the stop value for the voltage output in analog output mode. At-
tempting to set the start value to a voltage greater than the stop value, or
the stop value lower than the start value, will result in an execution error.
Query: OBVSP?
Returned
String: OBVSP ,
OBVST BNC analog output start voltage scale BNC
Syntax: OBVST ,
port: 1 or 2
val: –5.00 to +5.00 Volts
Remarks: Sets up the start value for the voltage output in analog output mode. At-
tempting to set the start value to a voltage greater than the stop value, or
the stop value lower than the start value, will result in an execution error.
Query: OBVST?
Returned
String: OBVST ,
OBZL BNC RF blanking output level when zeroing BNC
Syntax: OBZL
level: HIGH (TTL high)
LOW (TTL low)
Remarks: Sets the TTL level of the BNC RF blanking output.
Query: OBZL?
Returned
String: OBZL
OFFCLR Clear an offset table SENSOR
Syntax: OFFCLR
val: 1 to 5
Remarks: Sets all the values in the table specified to 0 dB and 0.00 Hz.
6-60 ML2430A OM
ML24XXA NATIVE COMMANDS GPIB OPERATION