Anritsu ML2430A - Manual (Page 120)

Returned
String: DCONT
DCONTD Set display contrast down by one DISPLAY
Syntax: DCONTD
Remarks: Make the display lighter by lowering the contrast by one level.
DCONTU Set display contrast up by one DISPLAY
Syntax: DCONTU
Remarks: Make the display darker by increasing the contrast by one level.
DISP Display On or OFF DISPLAY
Syntax: DISP
state: ON or OFF
Remarks: When using GPIB measurement, speed can be increased by not updating
the display. This command turns off the display and writes
REMOTE across the screen. If the LOCAL soft key is pressed, the system
reverts to DISP ON. The restrictions of this mode are:
1. Min max values read via the GPIB are not updated.
2. Relative operation is ignored so that the normal value is given.
3. DISP will not operate when sent via RS232.
Query: DISP?
Returned
String: DISP
DPEAK Peak meter display DISPLAY
Syntax: DPEAK
mode: A
B
A&B
OFF
Remarks: Turns the peak meter display on or off for each channel.
A = Sensor A only
ML2430A OM 6-33
GPIB OPERATION ML24XXA NATIVE COMMANDS