Anritsu ML2430A - Manual (Page 214)

Remarks: Triggers a single reading which is added to the internal digital filter and the
updated filter power level is returned on the GPIB. After a TR1 command,
the instrument returns to TR0 standby mode.
Related
Commands:
TR0, TR2, TR3, *TRG, Group Execute Trigger (GET), GT0, GT1, GT2
TR2 Trigger with a settling delay
Syntax: TR2
Remarks: Triggers a new series of readings; enough to update the internal digital fil-
ter for a noise free reading at the current power level. The value is then re-
turned on the GPIB and returns to TR0 standby mode.
Related
Commands: TR0, TR1, TR3, *TRG, Group Execute Trigger (GET), GT0, GT1, GT2
TR3 Trigger free run
Syntax: TR3
Remarks: Sets the ML2430A Series back into free run mode on both channels.
Related
Commands: TR0, TR1, TR2, *TRG, Group Execute Trigger (GET), GT0, GT1, GT2
ZE Zero sensors
Syntax: ZE
Remarks: Zero all connected sensors. The ML2430, when emulating the HP 438,
may take longer to Zero a sensor than the HP 438 itself. When performing
a zero the status byte should be used to identify when ZEROing is com-
plete.
ML2430A OM 6-127
GPIB OPERATION HP 438A EMULATION COMMANDS