Anritsu ML2430A - Manual (Page 245)

B-5
HP 437B QUICK
REFERENCE The following table references HP 437B emulation mode commands.
Table B-16. HP 437B Emulation Commands
Command Function Page
*CLS Clear GPIB status bytes 6-12, 6-100
*ESE Event Status Byte enable 6-7, 6-12,
6-100
*ESE? Return Event status register enable mask 6-14, 6-54,
6-101
*ESR? Event status register request 6-14, 6-54,
6-101
*RST Reset device 6-102
*SRE Setup service request enable register 6-102
*SRE? Return Service Request enable register 6-102
*STB? Return status byte register 6-102
*TST? Self Test 6-102
@1 Set SRE mask 6-103,
6-117
CL Cal Adjust 6-103,
6-118
CS Clear all status bytes 6-103,
6-119
CT Clear cal factor table 6-104
DA Display All 6-104,
6-119
DC Duty cycle state 6-104
DD Display disable 6-104,
6-119
DE Display enable 6-105,
6-119
DF Display disable 6-105
DR Set GPIB address 6-105,
6-120
DY Duty cycle 6-105
EMUL GPIB emulation mode 6-105
EN Enter command 6-106
ET Enter cal factor table data 6-106
EX Exit 6-106
FA Auto average 6-107,
6-120
FH Average hold 6-107,
6-120
FM Set average value 6-107,
6-121
FR Frequency of the input signal 6-107
ML2430A OM B-11
APPENDIX B HP 437B QUICK REFERENCE