Anritsu ML2430A - Manual (Page 176)

Set the offset value at the specified memory location in
dBm.
Syntax: MOF<;>
mem: Memory location 1 to 30.
value: Offset value in dBm.
Remarks: Set the offset value at memory store address to dBm
MRF Set the reference value at the specified memory location in
dBm.
Syntax: MRF<;>
mem: Memory location 1 to 30.
value: Reference value in dBm.
Remarks: Set the reference value at memory store address to dBm.
ODT Output the current calibration factor, offset value, and refer-
ence level.
Remarks: These are output as three separate messages in the output buffer, as
shown below:
CAL factor: 18 ASCII characters +
OFFSET value: 18 ASCII characters +
REFERENCE level: 19 ASCII characters +
NOTE
When the ODT, OMR, and OPW data output commands
are received simultaneously, only the command which is
received last is valid.
ML2430A OM 6-89
GPIB OPERATION ML4803A EMULATION COMMANDS
C A L
O F F S E T
R E F E R E N C E d B
d B
d B m .
.
.
5 CHARACTER DATA
10 15 5 1
Figure 6-3. ODT Data Output Format