Anritsu ML2430A - Manual (Page 116)

units: W (Watts)
DBM (dB)
DBUV (dB
mV)
DBMV (dBmV)
Remarks: DBM 0dB is equal to 1mW readout mode
W = Watts readout mode
V = Volts readout mode. This selection is automatically made when the
channel input configuration is set to External volts (EXT V).
DBUV = dB
mV, 0dB is equal to 1mV in readout mode.
Query: CHUNIT?
Returned
String: CHUNIT ,
When the channel input configuration is set to External volts (EXT V), the
returned units are always volts, irrespective of what units have been set.
CONT Continue GPIB SETUP
Syntax: CONT
Remarks: This command will allow the system to continue the startup sequence if
there are self test failures other than DSP errors.
Related
Commands: STERR, START
CUR Cursor in Power vs. Time and Source Sweep modes SYSTEM
Syntax: CUR ,
cursor: 1 or 2
fval: 0.0 to 1440 minutes (24 hours) in Power vs. Time mode
In Source Sweep mode, Power sweep : –120.0 dB to 30.0 dB
In Source Sweep mode, Frequency sweep : 10.0 KHz to 122.0 GHz
Remarks: In Power vs. Time mode, the fval parameter is in minutes. In Source Sweep
mode, the fval parameter is in dB or Hz for a power sweep or frequency
sweep respectivily.
Examples:
Power vs. Time:
Set cursor 1 to 30 seconds:
CUR 1,0.5
Set cursor 2 to 12.5 hours: CUR 2,750
Source sweep:
Power Sweep, set cursor 1 to 11.5 dB:
CUR 1,11.5
Frequency Sweep, set cursor 2 to 15.6 GHz: CUR 2,15.6GHz
ML2430A OM 6-29
GPIB OPERATION ML24XXA NATIVE COMMANDS