Anritsu ML2430A - Manual (Page 165)

After a TR2 command the instrument returns to either TR0 (trigger hold) or
TR3 (trigger free run) mode depending on what it was previously set to.
Related
Commands: TR0, TR1, TR3, *TRG, Group Execute Trigger (GET), GT0, GT1, GT2
TR3 Trigger free run GPIB TRIGGER
Syntax: TR3
Remarks: Sets the ML2430A Series back into free run mode on both channels.
Related
Commands: TR0, TR1, TR2, *TRG, Group Execute Trigger (GET), GT0, GT1, GT2
TRGARM Trigger arming TRIGGER
Syntax: TRGARM ,
c: 1, 2 or 1&2
state: ON or OFF
Remarks: Sets the readout trigger arming ON or OFF when in READOUT or
POWER vs. TIME mode.
Select channel 1, 2 or 1&2. Selecting 1&2 allows both channels to trigger
together on the same conditions without having to set up two sets of trig-
ger data.
If set to ON, the system first checks to see if the BNC sweep blanking input
is TRUE before it starts to trigger. If set to OFF, the system uses the trigger
source (TRSRC) to decide when to trigger.
TRGARM will return an execution error if trying to set trigger arming ON
when a display channel trigger source is already set to EXTTTL, as they
both use the same BNC input.
Query: TRGARM?
Returned
String: TRGARM ,
The TRG type commands return the trigger state of the selected channel if
the channel is ON. This depends on the settings of the “link triggers” flag
and the current mode of the sensor on the selected channel. If the channel
is OFF, the stored trigger state of the channel is returned.
TRGDLY Trigger sample delay TRIGGER
Syntax: TRGDLY , [units]
6-78 ML2430A OM
ML24XXA NATIVE COMMANDS GPIB OPERATION