Anritsu ML2430A - Manual (Page 134)

Remarks: Sets the profile trigger arming ON or OFF. If set to ON, the system first
checks to see if the BNC sweep blanking input is TRUE before it starts to
trigger. If set to OFF, the system triggers on whatever trigger source it has
been set up for.
Query: GTARM?
Returned
String: GTARM
GTDLY Set profile trigger sample delay TRIGGER
Syntax: GTDLY [units]
val: 0.0 to 1.0 seconds
Remarks: Sets the time delay after the display trigger delay to when the system
starts to take readings and displaying them. This point is represented by
the left most cursor.
NOTE
Changing the left most cursor or trigger delay time updates
either the cursor or the delay time value.
Query: GTDLY?
Returned
String: GTDLY
GTGW Set profile trigger gate width TRIGGER
Syntax: GTGW [units]
val: 100ns to 7.0 seconds
Remarks: Sets the time the system uses to perform whatever calculations are set up.
The time interval is represented by the space between the left most cursor
and the right most cursor. Changing either cursor, or the Gate width value,
will update both the cursors and the gate width value. The default gate
width value is 20 ms.
Query: GTGW?
Returned
String: GTGW
GTLVL Set profile trigger level TRIGGER
ML2430A OM 6-47
GPIB OPERATION ML24XXA NATIVE COMMANDS