Anritsu ML2430A - Manual (Page 250)

B-7
HP-IB SUPPORT The following tables list HP-IB commands for the HP 437B and HP 438A
power meters, and which commands are supported in the Anritsu
ML2430A Series power meter. Restrictions, if any, are also listed. Com-
mands that are not supported will be ignored.
HP 437B Commands
Mnemonic Action Supported? Restrictions
CL CAL 0 dBm Yes None
*CLS Clear Status Yes None
CS Clear status Yes None
CT0-CT9 Sensor data tables Yes None
DA Set all screen pixels Yes None
DC0 Duty cycle OFF Yes None
DC1 Duty cycle ON Yes None
DD Disable display Yes DISP OFF restrictions: Screen and
min/max not updated, Relative not active
DE Display enable Yes DISP ON. None.
DF Disable Display Yes see DD
DN Down arrow No Not supported
DU User message No Not supported
DY Duty cycle Yes None
EN Enter msg terminator Yes None
ERR? Error query No Not supported
*ESR? Read event reg Yes None
*ESE Set event enable reg Yes None
*ESE? Read event enable reg Yes None
ET0-ET9 Edit cal factor table Yes None
EX Exit Yes None
FA Auto average Yes None
FH Average hold Yes None
FM Manual average Yes None
FR Set frequency Yes Switch to frequency cal factor source.
GT0 Ignore GET Yes None
GT1 TR1 on GET Yes None
GT2 TR2 on GET Yes None
GZ Terminator Yes None
HZ Terminator Yes None
ID Return ID string Yes None
IDN? Return ID string Yes None
KB Set cal factor Yes None
KZ Terminator Yes None
LG Units to dBm Yes None
LH Set high limit Yes On channel not sensor.
LL Set low limit Yes On channel not sensor
LM0 Limit check off Yes Both high and low off as HP 437B
B-16 ML2430A OM
HP-IB SUPPORT APPENDIX B