Anritsu ML2430A - Manual (Page 115)

CHCFG Channel input configuration CHANNEL
Syntax: CHCFG ,
c: 1 or 2
config: OFF,
A, B, V
A–B, B–A
A/B, B/A
Remarks: A, B, V = Sensor A, Sensor B, or External Volts
(If V is sent when in Profile or Source Sweep mode, an execution error will
occur.)
A–B, B–A = Sensor A minus Sensor B, Sensor B minus Sensor A
A/B, B/A = Sensor A divided by Sensor B, Sensor B divided by Sensor A
Example: To set channel 2 to A–B:
CHCFG 1,A-B
Query: CHCFG?
Returned
String: CHCFG ,
CHRES Set channel decimal point resolution CHANNEL
Syntax: CHRES ,
c: 1 or 2
val: 1 to 3
Remarks: Set the number of decimal places displayed for the specified channel. For
example, specifying CHRES 1, 1 would yield a display of 1.5 dBm; CHRES
1, 2 would yield 1.47 dBm; CHRES 1, 3 would yield 1.468 dBm. If the num-
ber to be displayed is too large for the number of decimal places selected,
the decimal places displayed will be reduced so that the display value can
be shown.
Query: CHRES?
Returned
String: CHRES ,
CHUNIT Set Channel units CHANNEL
Syntax: CHUNIT ,
c: 1 or 2
6-28 ML2430A OM
ML24XXA NATIVE COMMANDS GPIB OPERATION