Allied Telesis AT-S24 - Manual (Page 57)

AT-S24 Version 2.01 User’s Guide
57
If you are running the Omega session from a web browser, you can
display the Terminal Configuration window by clicking on the RS232
port in the graphical display of the switch.
3. Adjust the settings as desired. The parameters are described below.
VT100-compatible / ANSI
Generic “dumb” terminal
These two selections are used to specify the type of terminal or
terminal emulator to be used with the RS232 port.
8 data bits
7 data bits
The default is 8 data bits.
1 stop bit
2 stop bits
The default is 1 stop bit.
No parity
Odd parity
Even parity
The default is no parity.
Full-duplex (echo)
Half-duplex (no echo)
These two selections control the duplex mode of the port. The port
can operate in full-duplex mode, meaning it can send and receive
data simultaneously, or half-duplex mode, meaning the port can
either send or receive data, but not both at the same time. The default
is full-duplex.
Data rate (“baud” rate)
This selection allows you to specify the speed of the port. When you
select this option, the Omega program displays a list of possible baud
rates. Possible baud rates are:
❑ 19200 bps
❑ 9600 bps (recommended setting for fixed baud rate)
❑ 4800 bps
❑ 2400 bps
❑ 1200 bps
❑ 600 bps
❑ 300 bps