Allied Telesis AT-S63 - Manual (Page 68)

Chapter 3: Basic Switch Commands
68 Section I: Basic Operations
SHOW CONFIG DYNAMIC
Syntax
show config dynamic[= module ]
Parameters
module Displays the settings of a particular switch module. You can
specify only one module at a time. For a list of modules, refer to
Table 3.
Description
This command displays the settings of the switch parameters that have
been changed from their default values, including those not yet saved to
the active boot configuration file. The parameters are displayed in their
command line command equivalents. You can view all of the settings or
limit the display to just those of a particular switch module. An example of
the display is shown in Figure 2.
Figure 2. SHOW CONFIG DYNAMIC Command
The MODULE variable is used to limit the display to the parameter
settings of a particular switch module. You can specify only one module
per command. The modules are listed in Table 3.
---Start of current configuration ------------------
#
# System Configuration
#
set system name="Production Server"
set system contact="Jane Smith"
set system location="Bldg. 2, room 411"
#
# IP Configuration
#
Table 3. Module Variable
Variable Description
ACL Port access control list
AUTH Manager and operator passwords (encrypted)
and RADIUS and TACACS+